Jump to content

2008 Honda four 75hp water pumping issue


2freeq

Recommended Posts

Hi all,

As the title says i'm having a issue with water not pumping out on my 75hp Honda Four.

The story so far is i brought the boat 2 weeks ago and it has been perfect. Took the kids on the lake on Sunday and spent 2 hours towing them around on the ski tubes. Motor was pumping water out peep hole perfectly every time i checked on it.  Upon arriving home i plugged the hose into the muffs to flush the motor as usual but no water was coming out top. Had a look and seen all the water was pumping out of a 10mm round hole next to where you can see the selector shaft just above gearbox (as seen on first pic and second pic of water pumping out). When i block that hole and my finger the water diverts to coming out around the selector shaft and a small amount makes it's way up the motor and barely dribbles out of top where it is suppose to be coming out (As seen in 3rd pic). Does anyone have any clue whats gone wrong and how do i fix it?

Cheers

1842946423_100mmhole.thumb.jpg.e70d30e4ad8dad314f8321c89b8d9175.jpg

585068465_waterpouringout.thumb.jpg.06afa963a7deae14783669c8bbc09b7e.jpg

396309201_waterouttop.thumb.jpg.5a186544baa2d91bedca6a1d1f10492f.jpg

Link to comment
Share on other sites

This motor has pumped water instantly every time i start the motor (well except for currently) so i don't think it's a thermostat issue. Maybe i need to drop the leg and have a look at the impeller as you suggested. Thanks mate.

Link to comment
Share on other sites

36 minutes ago, kingfishbig said:

First thing I would try is running some heavy fishing line into the tell tale while the motor is running. Quite often it's just a matter of a few grains of sand or slime causing a blockage.

Thanks, I'll give that a go tomorrow. I did pop the tell tale out and can blow freely back through the hose. 

Link to comment
Share on other sites

Sometimes the impellor vanes deteriorate right at the base where they will crack and get to the point where they will rip right off withour warning leaving just the guts attached to the drive shaft.

Pull off the water intake screens on the leg too see if theres any bits of rubber in there as that's where they usually end up.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...